It must always start with the definition of the trigger event. As a start condition either an "!i: Input event", "!t: Time event", "!rc: Real time clock event", "!v: Variable event", "!d: DMX event" or "!k: Infrared event" can be used.

 

 

Attention!

The limit is one trigger event per line (!i, !t, !rc, !v, !d or !k)!

Only variable conditions can be combined in one line. If you need a combination of several trigger events you have to do this via variables.

This trigger event can ONLY be executed by the ProCommander® 2/3!

 


!k: Infrared event

A infrared remote control can be used to start a command line. Input 1 to 10 can be used, whereby the digit 0 is equivalent to 10.


A level change may be defined as "close" (activation of an input), "open" (deactivation of an input) or "toggle" (every level change of an input). With toggle, both the press and the release of a key action will cause a trigger event.


Example:

 

!k1c!...# -> If input 1 on the infrared remote control is activated (c=close), then the downstream command will be executed.

 

!k5o!...# -> If input 5 on the infrared remote control is deactivated (o=open), then the downstream command will be executed.

 

!k0t!...# -> If input 10 on the infrared remote control changes (t=toggle), then the downstream command will be executed.