It must always start with the definition of the trigger event. As a start condition either an "!i: Input event", "!t: Time event", "!rc: Real time clock event", "!v: Variable event", "!d: DMX event" or "!k: Infrared event" can be used.

 

 

Attention!

The limit is one trigger event per line (!i, !t, !rc, !v, !d or !k)!

Only variable conditions can be combined in one line. If you need a combination of several trigger events you have to do this via variables.

 


!v: Variable event


For basic information about the variables read the chapter "Variable" in the instruction manual of the ProCommander®.

After each change of a variable the Control.ini file is checked, if an event is assigned to this variable.

If this condition is true, the downstream command will be executed. As operators > < = ~ are permitted.

Example:

!vcc2=3!...# -> If the value of variable 2 is equal the value of variable 3, then the downstream command will be executed.

!vcv3<11!...# -> If the value of variable 3 is less than the value of variable 11, then the downstream command will be executed.

!vcv80<44!...# -> If the value of variable 80 is greater than the value of variable 44, then the downstream command will be executed.

!vcc4~1!...# -> If the value of variable 4 is unequal to the value of variable 1, then the downstream command will be executed.