Download the latest firmware version:

ProCommander® LTC Firmware Update V304



 

Attention!

Please note to check settings before connecting devices, after the update.  



Network updates through Configurator or Conductor should always be attempted prior to USB firmware procedures  Only upon hard stop failure (no display on the screen) should USB be required. This is considered an advanced procedure  Please make certain to watch the tutorials on this page for Weigl Hardware Configurator prior to performing any upgrades and always use proper data integrity procedures. 


Only if your units are inoperable and not visible to the network; USB DFU restore instructions are located here:  




Please note, install FlipInstaller first and follow:

Instructions for USB - driver installation and Firmware Update



 

Attention!

Please note, if your are using Windows 7 or Windows Server 2008 as your operating system, you need to update your system, before you are able to run an USB Update on your device. Please download the   correct update for your system.