ConductorPro Command Lists for the Pro VP™ & ProCommander® VX (Conductor 2.0.5058 or newer required)
Grab this easy to use drag and drop Pro VP™ commands list for ConductorPro. Included are all the following most common Weigl WEM | Script Ascii Commands sent from a ProCommander to a Pro VP™ or from the ProCommander® VX to its onboard video player. Check back often as these change frequently:
- Play
- Loop
- Stop
- Pause
- Previous
- Next
- Seek
- Run script
- Add
- Unload
- Select track
- Once script
- After
- Message
- Restart
- Reboot
- Shutdown
- Set audio
- Set video cleanup
- Set video background color
Notes:
- All commands include the as shipped default IP and port address of the player 1 on a Pro VP™ and ProCommander® VX. These settings can be changed in each command as needed for your configuration. Note: for the ProCommander® VX serial commands, serial port 8 is included in the command examples and must be the port which is utilized.
- Any commands which contain a video file or script path must be changed for your specific Pro VP™ media file naming and file paths configuration.
- For the Serial Channel ProCommander® VX commands list below, be sure to configure the serial channel in Conductor Pro to: port 8, baud rate: 115200, stop bits: 1, parity: none, data bits: 8.
- For the Command Channel ProCommander® VX commands list below, ProCommander® VX firmware v2.98 or newer is required.
Please ensure you have ConductorPro 2.0.5058 or newer to use these command lists:
Conductor Pro Command List - UDP Commands for Pro VP™ and ProCommander® VX
Conductor Pro Command List - Serial Channel Serial Commands for ProCommander® VX
Conductor Pro Command List - Command Channel Serial Commands for ProCommander® VX